Center Tapped Transformer
Center Tapped Transformer - Related Videos
11:45
Experimental Methods for Trapping Ions Using Microfabricated Surface Ion Traps
0 Views •
Cited by 19 •
2017
This paper presents a microfabrication methodology for surface ion traps, as well as a detailed experimental procedure for trapping ytterbium ions in a room-temperature environment.
10:13
A Microfluidic-based Hydrodynamic Trap for Single Particles
0 Views •
Cited by 14 •
2011
In this article, we present a microfluidic-based method for particle confinement based on hydrodynamic flow. We demonstrate stable particle trapping at a fluid stagnation point using a feedback control mechanism, thereby enabling confinement and micromanipulation of arbitrary particles in an integrated microdevice.
13:39
Optical Trapping of Nanoparticles
0 Views •
Cited by 7 •
2013
The following setup approach details low power optical trapping of dielectric nanoparticles using a double-nanohole in metal film.
01:41
Social Traps
0 Views •
2020
Social traps are negative situations where people get caught in a direction or relationship that later proves to be unpleasant, with no easy way to back out of or avoid. The concept was orignally introduced by John Platt who applied psychology to Garrett Hardin's "Tragedy of the Commons", where in New England herd owners could let their cattle graze in the common ground. This situation seems like a good idea, but an individual could have an advantage. If they owned more cows, the larger...
05:57
Dean-Stark Trap
0 Views •
2023
Source: Vy M. Dong and Jan Riedel, Department of Chemistry, University of California, Irvine, CA A Dean-Stark trap is a special piece of glassware, which allows the collection of water during a reaction through an azeotropic distillation. The desire to collect water from a reaction can have various reasons. It can drive the equilibria in reactions, where water is formed as a byproduct. According to Le Chatelier's principle, a change in temperature, pressure, concentration, or volume will cause...
FAQs
During each AC half-cycle, the two secondary sections present equal voltages with opposite polarity when measured from the center tap. This polarity relationship lets a circuit select the section that is correctly oriented for the desired current path, rather than treating the secondary as one undivided winding. It is the electrical basis for alternating conduction in rectifier and push-pull arrangements.
Using the center tap as a reference provides access to two equal secondary voltage sections. A circuit can therefore obtain a voltage from either section or use connections spanning both sections, depending on the required arrangement. This flexibility supports multiple voltage outputs and gives designers more than one way to route alternating current through a power-conversion circuit.
Both use alternating action in the two secondary halves, but their purposes differ. In the rectifier, two diodes use the center tap so the alternating input is converted into pulsating DC. In a push-pull power circuit, the two halves are driven alternately as part of the power-conversion process. One arrangement emphasizes rectification, while the other emphasizes alternating drive.
Connect the center tap as the winding reference, connect each end of the secondary to its diode, and arrange the diode paths so the appropriate half conducts during each AC half-cycle. The two alternating paths then deliver pulsating DC at the rectifier output. This arrangement uses the winding’s opposite-polarity sections to produce rectification through alternating circuit paths.
It is useful when a design needs multiple voltage outputs, alternating circuit paths, or a straightforward connection for full-wave rectification or push-pull operation. The configuration can simplify circuit layouts while preserving electrical isolation between the primary and secondary. These features make it relevant to power-conversion designs in which controlled routing of AC energy is important.
Electrical isolation separates the primary-side circuit from the secondary-side circuit while electromagnetic induction transfers energy between them. In a center-tapped design, that isolation can be combined with access to two balanced secondary sections. Engineers can consequently address voltage-output or power-conversion requirements without directly connecting the primary and secondary conductors, supporting flexible circuit layouts.